Quantum LTO-3 Model B Installation Manual page 13

Figure 18 Connecting Two
Drives on One SCSI Bus
Installing a Second Tape Drive or Replacing a Tape Drive
LTO-3 (Model B), LTO-4 (Model B), LTO-5, LTO-6, and LTO-7
SCSI bus 1
cable
Tape drive 1
Note: When adding a second tape drive for configurations using a single SCSI bus,
unplug the SCSI cable from tape drive 1, pass the end of the cable through the
internal rackmount enclosure openings, and connect the end port to tape drive
2. Then plug the middle port into tape drive 1. The SCSI terminator is at the end
of the cable and should be behind tape drive 2.
Note: Each SCSI device on the same SCSI bus must have a unique SCSI ID. Be sure that
the SCSI ID is different for each tape drive and that neither is set to SCSI ID 7.
Connecting One Drive per SCSI Bus
Use the configuration shown in
separate SCSI bus.
Tape drive 2
Figure 19 when connecting each tape drive to a
SCSI ID cables,
one for each
tape drive
SCSI terminator
13