Chapter2 Quick Start; Brief Introduction - ITech IT8600 Series User Manual

ООО "Техэнком" Контрольно-измерительные приборы и оборудование

2.1 Brief Introduction

This chapter describes the power-on inspection steps of IT8600 electronic load
to ensure the normal startup and use in the initial state, and the front panel, rear
panel, key functions and LCD (Liquid Crystal Display) functions of IT8600 series
loads to help the user know the appearance, structure and key functions before
operation and better operate these loads.
The IT8600 programmable AC/DC load, using a 3U small structure to realize
the input of 420V/20A/1800W, has a powerful function of data measurement. In
addition to measurement of such conventional parameters as Vrms, Vpk, Vdc,
Irms, Ipk, Idc, W, VA, VAR, CF, PF and Freq, the load has the unique function of
voltage harmonic analysis to test harmonic interference of the test object (UPS,
generator, etc.) to the power grid. At most 50 voltage harmonics can be
analyzed.
The highlight of IT8600 programmable AC/DC load is the oscilloscope display,
which can display the input voltage and current waveform of the test object. In
the harmonic measurement mode, analysis results of the percentage of each
kind of harmonics can be displayed in the bar form. Multiple display modes
bring new user experience.
IT8600 programmable AC/DC load can be used in parallel connection of
multiple units and three-phase parallel connection to test three-phase AC power
supplies or power supplies of high power. In three-phase parallel applications,
the user can select the Y-type and Δ-type connection according to the actual
requirements. Flexible connection can meet various test requirements.
IT8600 programmable AC/DC load includes the standard GPIB, LAN and USB
communication interface for fast and stable communication.
⚫
Frequency range: 45-450HZ
⚫
7-inch LCD screen
⚫
Parallel/three-phase control
⚫
Oscilloscope function for display of the voltage and current waveform
⚫
Measure Vrms, Vpk, Vdc, Irms, Ipk, Idc, W, VA, VAR, CF, PF and FREQ
⚫
Measure the THD (V) parameters of 50 harmonics at most
⚫
AC electronic load: CC/CR/CP mode
⚫
DC electronic load: CC/CR/CP/CV mode
⚫
External 0-10V analog control
⚫
OTP, OCP, OVP, UVP and OPP protection
⚫
GPIB, LAN and USB communication interface and external USB interface
Note
①②: CV mode and external 0-10V analog control function are only for IT8615 and
IT8615L.
Model Voltage
IT8615 420V
IT8615L 260V
IT8616 420V
IT8617 420V
Copyright © ITECH Electronic Co., Ltd.

Chapter2 Quick Start

①
②
and voltage/current analog monitoring
Current
20A
20A
40A
60A
www.tehencom.com
Quick Start
Power
1.8KW
1.8KW
3.6KW
5.4KW
13