Pm Motor Auto-Tuning Error - TECO F510 Series Quick Setting Manual

Error
Check the motor

09 tuning data (17-00 to
Other auto-tuning 17-09).
errors Check motor

connection.

4.5 PM Motor Auto-tuning Error

When a fault occurs during auto-tuning of a
PM motor, the display will show the "IPErr"
fault and the motor stops. The fault
information is displayed in parameter 22-22.
Note: The fault contact output does not
energize with an auto-tuning fault.
Refer to Table 4.4, for fault information
during tuning, cause and corrective
action.
Table 4.4 Auto-tuning fault and corrective
actions for PM motor
Error

01
Magnetic pole
alignment tuning

failure (static).
02~04 Reserved

05
Circuit tuning time
out.
06 Reserved

07
Other motor tuning

errors.
08 Reserved

09
Current out of
range during circuit

tuning.
10 Reserved

11
Parameter tuning
and detecting time
out.

Corrective action
Corrective action
Check the motor
tuning data (22-02).
Check inverter
capacity
Check for active
protection functions
preventing auto-
tuning.
Check the motor
tuning data (22-02).
Check motor
connection.
Check the motor
tuning data (22-02).
Check inverter
capacity
Check if the setting
value of parameter 22-
11 is too low, but its
value cannot exceed
100% of the inverter.
Check motor
connection.
57