To Set Up A Stand-Alone Rc642D Room Controller; To Set Display Options - Automated Logic RC642 Technical Instructions

12 Click Download Selected Items.
13 After the download is complete, set DIP switch 8 to On.
14 Cycle the Room Controller's power off, then on again.

To set up a stand-alone RC642D Room Controller

To set display
1
options
2
3
NOTE The Fahrenheit/Celsius setting affects only the display. The control program uses
the units that were set up in the control program.
NOTE If the download fails, the Room Controller appears in the Failures box. Since
this indicates a system problem, do not clear the failure. Locate and resolve the
problem, then retry the download. To retry, select the controller in the Failures box,
then repeat steps 4 and 5 above.
Remove power from the Room Controller.
Set DIP switches 5 and 6 as needed.
To have the Room Controller's
default screen show...
Time
Temp
To show temperatures as...
Fahrenheit
Celsius
Apply power to the Room Controller.
Set DIP switch 5 to...
On
Off
Set DIP switch 6 to...
Off
On
36