Other Programming - Panasonic KX-TGF770 Series Operating Instructions Manual

Programming
Editing an outside monitoring number
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line.
5
MMENUN a MbN: "Edit" a MSELECTN
6
Edit the name if necessary. a MOKN
7
Edit the phone number if necessary. a
MOKN a MSELECTN
Erasing an outside monitoring
number
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MSELECTN
3
MbN: "On" a MSELECTN
4
MbN: Select the outside line.
5
MMENUN a MbN: "Erase" a MSELECTN
6
MbN: "Yes" a MSELECTN a MOFFN
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
Handset
1
Press MMENUN on the handset being
monitored.
2
MbN: "Sensitivity level" a
MSELECTN
3
MbN: Select the desired setting. a
MSAVEN a MOFFN
For assistance, please visit http://shop.panasonic.com/support
62
TA Manual̲KX-TGF7xxUS̲series.pdf 62
Answering the baby monitor
n When monitoring with a unit:
Handset: Press M N to answer a call.
Base unit: Press MZN to answer a call.
If you want to respond from the monitoring
unit, press MMUTEN.
R The monitoring unit will answer calls
automatically when the auto intercom
feature is set to "On" (page 36).
Note:
R If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds.
– To answer the call with the handset,
press MOFFN, then press M
– To answer the call with the base unit,
press MZN 3 times.
*1 If MMUTEN is pressed, press MZN 2
times.
n When monitoring from outside:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialing.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 63).
Handset
1
MMENUN#104
2
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
N.
*1
2018/09/27 8:25:59