Mechanical Specifications; Electrical Specifications - MSA General Monitors FL500 UV/IR Operating Manual

8.2

Mechanical Specifications

Enclosure material
Color
Finish
Height
Width
Depth
Weight
Cable Entry
Earth Terminals
8.3

Electrical Specifications

Nominal supply voltage
Supply voltage range
Maximum operating
supply current
Typical operating
supply current
Peak inrush supply current
Maximum output signal load 600 ohms
Output signal range
Fault signal
COPM fault signal
Ready signal
IR only signal
UV only signal
Alarm Low signal
Alarm High signal
Relay contact ratings
RS-485 output
HART
HART impedance
RFI/EMI protection
Status indicator
316 Stainless Steel
Red
TGIC polyester powder coat
6.4 in. (16.2 cm)
5.0 in. (12.7 cm)
4.3 in. (11.0 cm)
9.4 lb (4.3 kg)
2 x ¾ in. NPT (M25 adapters included for some configurations)
8-32 x 3/8 Philips pan-head screw, stainless steel, zinc-plated, green
dye; external stainless steel tooth lock washer included. Applicable
for connection of 4 mm
24 Vdc
20 to 36 Vdc (measured at device)
200 mA during COPM only
80 to 150 mA
860 mA @ 18.5 VDC, 900 mA @ 24.0 VDC, 964 mA @ 36.0 VDC.
Supply voltages are at the detector
0 to 20 mA *
0 to 0.2 mA *
2.0 ±0.2 mA *
4.0 ±0.2 mA
8.0 ±0.2 mA
12.0 ±0.2 mA
16.0 ±0.2 mA
20.0 ±0.2 mA
North American Approved Applications:
SPDT, 5A @ 250 Vac, or 5A @ 30 Vdc resistive max.
European Union (EU) Approved Applications:
SPDT, 5A 30V RMS/42.4V Peak, or 5A @ 30 Vdc resistive max.
Modbus RTU
128 devices in series max. (247 devices with repeaters)
Baud rate: 2400, 4800, 9600, or 19200 bps
Fully HART 7 FieldComm compliant. Refer to the FL500 HART
Communication Operating Manual (PN 10193215).
RX = 50 K CX = 5 nF
Complies with EN 50130-4 and EN 61000-6-4
Three LEDs identify status, fault, and alarm conditions
FL500 UV/IR, FL500-H Flame Detector
2
2
or smaller.
Specifications
38
US