Custom Osd - RGBlink RGB-RD-UM-M2 E003 User Manual

6.3.2 Custom OSD

Double click the icon
window as follows:
Follow the steps below:
Tick OSD ON/OFF.

Set the parameters as needed.

Note:
- Up to two lines of OSD can be displayed on a page at a time.
- The font settings can be saved in the PC, and can be reused without another editing.
After editing, load the OSD into the device. There are two ways to load.
(1) Load OSD directly with LAN cables.
- Change the COM No. of XTOOL according to the COM No. of the PC ([Management]).
If an exclamation mark appears in the COM, restart the PC.
- Click [Save To Device].
(2) Load OSD with USB
- Click [Save to Computer] and save in order (0~199).
- Save the file as M2\OSD.
to enter to the XTOOL interface, select "Toolbox", and enter to the
Chapter 6: Appendix
72