CanyCom MASAO CMX 2502 Operator's Manual page 75

5
Blade Pin
5331M-0508-010E
5332M-0508-040E
Rotor Stay
Flat Surfaces
Blade Pin
5332M-0508-020E
Maintenance
Wear Limit
New
Replace when either
of the part wears out
15mm
When New
Mounting Slot
Blade
Rotating Direction
Wave Washer
Inspecting
1. Open cutting blade shield.
2. Visually inspect blades and pin for wear
and damage. If blades are worn normaly,
turn them over and use. Replace if both
edges are worn. If blades or pin are worn
excessively, deformed, damged, or missing,
replace them with new ones.
NOTE
• Wear Limit
Blade: Up to line connecting outer edge and
inner edge.
Blade Pin: Up to either of the shoulder.
3. Inspect cutting rotor stay. If stay is worn
excessively, deformed or damged, contact
your CANYCOM representative and have it
replaced with new one.
4. Close blade sheild.
NOTE
• Wear Limit: Up to the solid line in the
left figure (should have more than 15mm
clearance between edge of rotor stay and
mounting slot.)
Mounting, Dismounting Hole
Lug Hole
Wear Area
Handle with care.
These parts may become sharp
-66-
Wear Area