Table of Contents
Advertisement
Replacing the Battery in the Remote Keyless Entry
System Transmitter
3. Read the instructions inside the case.
4.
Put the two halves back together.
Make sure
the
cover is on tightly, so water won't get in.
5. Check the operation of the transmitter with your
vehicle. If the transmitter does not work, try
synchronizing the transmitter with the receiver.
Synchronization
Your remote keyless entry system is equipped with a
security system that prevents anyone from recording
and playing back your signal. The transmitter does not
send the same signal twice to the receiver. The receiver
will not respond to a signal that has been sent to
it more
than once.
To resynchronize your transmitter and receiver, follow
To replace the battery in the transmitter:
1. Use a small coin or flathead screwdriver to separate
the bottom half from the top half of the transmitter.
2. Remove the battery and replace it with the new one.
Make sure
the
positive
(+)
side
of the
battery
faces
down. For battery replacement, use
a
3-volt battery,
type CR2032, or equivalent.
these directions:
1. Stand close to your vchicle.
2 . Press and hold the LOCK and UNLOCK buttons on
the transmitter at the same time.
3. Hold the buttons for at least five seconds. During
this time, the doors should lock and unlock once.
This confirms the resynchronization.
If
the
doors
do
not lock and unlock, see your dealer for service.
2-9
-
Advertisement
Table of Contents
