Pontiac 1998 Sunfire Owner's Manual page 158

Adjusting the Speakers
BAL: Press this knob lightly so it extends. Turn it
to
move the sound to the left or right speakers. The middle
position balances the sound between the speakers.
FADE: Press this knob lightly so it extends.
Turn it to
move the sound to the front or rear speakers. The middle
position balances the sound between the speakers.
Push
these
knobs back
into their stored positions when
you're not using them.
Playing a
Cassette Tape
Your tape player is built to work best with tapes that are
30 to 45 minutes long on each side. Tapes longer than
that are so thin they may not work well in this player.
While the tape is playing, use the VOL,
FADE
and BAL
controls just
as
you do for the radio. The display will
show an arrow to show which side of the tape is playing.
When the down indicator m o w is lit, selections listed
on the bottom side of the cassette are playing, When the
up
m o w is lit, selections listed on the top side of the
cassette are playing. The tape player automatically
begins playing the-other side when it reaches the end of
the tape.
If E and a number appeax-
on
the
I--
'io
1
;ky, the tape
won't play because of an errorL
E10:
The tape
is
tight and the player can't turn the
tape hubs. Remove
the
tape. Hold the tape with the
open end down and t r y to turn the right hub to the
left with a pencil. Turn the tape 'over and repeat. If
the hubs do not turn easily, your tape may be
damaged and should not be used in the player.
Try a new
tape to
make sure
your player is
working properly.
<.
Ell:
The tape is broken. Try a new tape.
If any error occurs repeatedly
OF
if an error can't be
corrected, please contact your dealer. If your radio
displays an error number, write it down and provide it to
your dealer when reporting the problem.
PREV (1): Press this button or the SEEK down arrow to
search for the previous selection on the tape. Your tape
must have at least
three
seconds of silence between each
selection for PREV or SEEK to work. The tape direction
arrow blinks during PREV or SEEK operation. Press
PREV or the SEEK down arrow to stop searching. The
sound will mute during PREV or SEEK operation.
3-14