Lexmark CS417 User Manual page 84

Understanding the printer menus
Use
Show Bookmarks
Yes
No
Web Page Refresh Rate
30–300
Contact Name
Location
Alarms
Alarm Control
Cartridge Alarm
Timeouts
Standby Mode
Disabled
1–240
Timeouts
Sleep Mode
Disabled
1–120
Timeouts
Print with Display Off
Allow printing with display off
Display on when printing
To
Specify whether bookmarks are displayed from the Held Jobs
area.
Note: Yes is the factory default setting.
Specify the number of seconds between Embedded Web
Server refreshes.
Note: 120 is the factory default setting.
Specify a contact name.
Note: The contact name is stored on the Embedded Web
Server.
Specify the location.
Note: The location is stored on the Embedded Web Server.
Set an alarm when the printer requires user intervention.
For each alarm type, select from the following options:
Off
Single
Continuous
Notes:
•
Single is the factory default setting. This sounds three
quick beeps.
•
Continuous repeats three beeps every 10 seconds.
Set the amount of time in minutes before the printer enters a
lower power state.
Note: 15 is the factory default setting.
Set the amount of time in minutes the printer waits after a job
is printed before it goes into a reduced power state.
Notes:
•
20 is the factory default setting.
•
Lower settings conserve more energy, but may require
longer warm‑up times.
•
Select the lowest setting if the printer shares an
electrical circuit with room lighting or you notice lights
flickering in the room.
•
Select a high setting if the printer is in constant use.
Under most circumstances, this keeps the printer ready
to print with minimum warm‑up time.
•
Disabled appears only if Energy Conserve is set to Off.
Print a job with the display turned off.
Note: Display on when printing is the factory default setting.
84