Advantech UTC-312 User Manual page 4

Safety Instructions
1. Read these safety instructions carefully.
2. Retain this user manual for future reference.
3. Disconnect this equipment from all AC outlets before cleaning. Use only a damp
cloth for cleaning. Do not use liquid or spray detergents.
4. For pluggable equipment, the power outlet socket must be located near the
equipment and easily accessible.
5. Protect the equipment from humidity.
6. Place the equipment on a reliable surface during installation. Dropping or letting
the equipment fall may cause damage.
7. The openings on the enclosure are for air convection. Protect the equipment
from overheating. Do not cover the openings.
8. Ensure the voltage of the power source is correct before connecting the equip-
ment to the power outlet.
9. Position the power cord away from high-traffic areas. Do not place anything over
the power cord.
10. All cautions and warnings on the equipment should be noted.
11. If unused for a long time, disconnect the equipment from the power source to
avoid damage from transient overvoltage.
12. Never pour liquid into an opening. This may cause fire or electrical shock.
13. Never open the equipment. For safety reasons, the equipment should be
opened only by qualified service personnel.
14. If one of the following conditions occur, have the equipment checked by service
personnel:
a. The power cord or plug is damaged.
b. Liquid has penetrated the equipment.
c. The equipment has been exposed to moisture.
d. The equipment is malfunctioning, or does not work according to the user
manual.
e. The equipment has been dropped and damaged.
f. The equipment has obvious signs of breakage.
15. Do not store the equipment in a environment where the temperature fluctuates
below -20 °C (-4 °F) or above 60 °C (140 °F). This may damage the equipment.
Instead, the equipment should be stored in a controlled environment.
16. If the computer clock consistently loses a significant amount of time or the BIOS
configuration resets to the default settings, the battery has no power.
Caution! 1.
2.
3.
4.
UTC-312 User Manual
Do not replace the power adaptor yourself. Contact a qualified
technician or your sales provider.
The computer is equipped with a battery-powered real-time clock
circuit. Batteries are at risk of exploding if incorrectly replaced.
Replace only with the same or equivalent type as recommended by
the manufacturer. Discard used batteries according to the manu-
facturer's instructions
During operation, the equipment may become soiled and, there-
fore, should be cleaned regularly using only alcohol or water.
To ensure environmental protection, follow national requirements
for disposing of the unit.
iv