ASSEMBLY INSTRUCTIONS (AERATOR)
1. Rest the float (D) on the cage, aligning the power cord to the notch in the float.
2. Locate the bolt holes marked with the indicators.
Indicator mark
3. Secure the float to the cage with the 1/4"-20 x 3-1/2" screws (A), 1/4" split lock washers (B), 3/4" OD flat
washers (C), and float retaining clips (E), as shown below.
4. Repeat for all three bolt holes.
3
C
E
D
A
B
Secure to top
ring of cage
Align power cord with this notch
4
1/2HP-1HP AERATOR & CIRCULATOR MANUAL
Back to Contents
5