ASSEMBLY INSTRUCTIONS (CIRCULATOR)
1. Slide the can strap (C) onto the unit with the flanges directly opposite the cage clamp. The strap should
be about 1.5 inches from the cage.
2. Secure the flanges together by fitting a 3/8"-16 x 1" hex head cap screw (H), two 3/8" flat washers (I), and
a 3/8"-16 nut (J) in the hole closest to the can.
3. Fit the bottom hole of each mounting bracket (B) over the hardware now securing the can strap flanges.
1
Cage clamp
C
3
B
1.5 inches
Flanges
J
I
Align this hole with flange hardware.
1/2HP-1HP AERATOR & CIRCULATOR MANUAL
Back to Contents
2
H
9