Electronic Sway Bar Disconnect - If Equipped - Jeep 2010 Wrangler Owner's Manual

352 STARTING AND OPERATING
The rear axle lock will disengage if the vehicle is taken
out of 4L (Low) range, or the ignition switch is turned to
the LOCK position.
ELECTRONIC SWAY BAR DISCONNECT — IF
EQUIPPED
Your vehicle may be equipped with an electronic discon-
necting stabilizer/sway bar. This system allows greater
front suspension travel in off-road situations.
This system is controlled by the SWAY BAR switch
located on the lower switch bank (below the climate
controls).
Sway Bar Switch
Press the SWAY BAR switch to activate the system. Press
the switch again to deactivate the system. The "Sway Bar
Indicator Light" (located in the instrument cluster) will
illuminate when the bar is disconnected. The "Sway Bar
Indicator Light" will flash during activation transition, or