Rear Door Removal (Four-Door Models) - Jeep 2010 Wrangler Owner's Manual

28 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
NOTE: If the red latch on the connector is locked, push
the red latch to the right until you can only see the latch
on one end (right) of the connector. This will unlock the
connector tab, allowing the tab to be pressed down and
enabling the harness to be disconnected.
1 — Harness Connector
2 — Body Hook
3 — Door/Harness Strap
3. Unhook the door strap from the body hook. Be careful
not to allow the door to swing fully open as the mirror
may damage paint.
4. With the door open, lift the door to clear hinge pins
from their hinges, and remove door.
To reinstall the door(s), perform the previous steps in the
opposite order.

Rear Door Removal (Four-Door Models)

1. Remove the hinge pin screws from the upper and
lower outside hinges (using a #T50 Torx head driver).