Windshield Washers; Adding Washer Fluid - Jeep 2008 Liberty Owner's Manual

remote start mode is exited. Refer to "Remote Start
System" in Section 2 of this manual for information on
remote start operation.

Windshield Washers

To use the washer, pull the Windshield Wiper / Washer
Control lever toward you and hold it for as long as
washer spray is desired.
If you activate the washer while the wiper control is in
the delay range, the wipers will operate in low speed for
two wipe cycles after releasing the lever and then resume
the intermittent interval previously selected.
If you activate the washer while the wiper control is in
the OFF position, the wipers will operate for two wipe
cycles and then turn OFF.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 145

Adding Washer Fluid

NOTE: Refer to the "Engine Compartment" diagram in
Section 7 for the location of the washer fluid reservoir.
The fluid reservoir for the windshield washers is located
in the engine compartment. Be sure to check the fluid
level in the reservoir at regular intervals. Fill the reservoir
with windshield washer solvent (not radiator antifreeze)
and operate the system for a few seconds to flush out the
residual water.
WARNING!
Commercially available windshield washer solvents
are flammable. They could ignite and burn you. Care
must be exercised when filling or working around
the washer solution.
3