Jeep 2008 Liberty Owner's Manual page 200

200 INSTRUMENT PANEL AND CONTROLS
once again to display the outside temperature and com-
pass heading in the screen below the speedometer. Refer
to "Vacuum Fluorescent Display" for details
Resetting the Trip Odometer
Display the trip mileage that you want to reset, "Trip A"
or "Trip B." Then push and hold the button (approxi-
mately 2 seconds) until the display resets to 0. The
odometer must be in Trip Mode to reset the trip odom-
eter.
26. 4WD Indicator Light — Vehicles Equipped with
Selec-Trac II
This light alerts the driver that the vehicle is in
the full-time four-wheel drive auto mode. In
this mode, the system operates with a normal
torque split of 42% front axle and 58% rear axle.
It can redirect up to 100% of torque to the front or rear
axle, if necessary.(See page 292 for more information.)
27. Odometer/Trip Odometer
The odometer shows the total distance the vehicle has
been driven. The trip odometer shows individual trip
mileage. Refer to "Trip Odometer Button" for additional
information.
NOTE: U.S. federal regulations require upon transfer of
vehicle ownership, the seller certify the mileage the
vehicle has been driven. Therefore, if the odometer
reading is changed because of repair or replacement, be
sure to keep a record of the reading before and after the
service so that the correct mileage can be determined.
Vehicle Warning Messages
When the appropriate conditions exist, messages such as
"door" (for door ajar), "gATE" (for liftgate ajar), "gLASS"
(for flip-up glass ajar), "gASCAP" (for fuel cap fault), or
"CHANgE OIL" will display in the odometer.