Changing The Air Filter (For Evaporator And Blower Unit) - Hyundai 2003 Accent Owner's Manual

G140D01A-AAT
Checking the Compressor Drive Belt
A/C
TENSION PULLEY
CRANK PULLEY
When the air conditioning is being used regular-
ly, the compressor drive belt tension should be
checked at least once a month with the engine
turned off.
To check the drive belt tension, press down on
the belt halfway between the engine crankshaft
and compressor pulleys. Pressing with your
finger, you should not be able to deflect this belt
anymore than 1/3 of an inch. If you have the
instruments to check it, with a force of 22 lb.
(98N), the deflection should be 0.315 inches
(approx. 8.0 mm). If the belt is too loose, have
it adjusted by your Hyundai dealer.
B145A01A-GAT
CHANGING THE AIR FILTER
(For Evaporator and Blower Unit)
0.315 in.
(If Installed)
(8mm)
The air filter is located in front of the evaporator
unit behind the glove box.
It helps to decrease pollutants from entering the
car and to filter the air.
G140D01A
1. Open the glove box and remove the adjust-
ing pins on both sides of the glove box.
DO-IT-YOURSELF MAINTENANCE
2. Remove the cable and the wiring from the
filter cover.
HLC2096
3. Remove the filter cover by pushing the upper
end of the filter cover.
6- 15
HLC2097
HLC2098