Checking The Climate Control Air Filter (For Evaporator And Blower Unit) - Hyundai H-100 Owner's Manual

G140B01A-AAT
Checking the Air Conditioning
Operation
1. Start the engine and let it run at a
fast idle for several minutes with the
air conditioning set at the maximum
cold setting.
2. If the air coming out of the in-dash
vents is not cold, have the air condi-
tioning system inspected by your
Hyundai dealer.
!
CAUTION:
Running the air conditioning sys-
tem for extended periods of time
with a low refrigerant level may
damage the compressor.
G140C01A-AAT
Lubrication
To lubricate the compressor and the
seals in the system, the air conditioning
should be run for at least 10 minutes
each week. This is particularly important
during cool weather when the air condi-
tioning system is not otherwise in use.
G140D01A-GAT
Checking the Compressor Drive
Belt
Tension
pulley
COMP. pulley
Crankshaft pulley
G140D01HR
When the air conditioning is being used
regularly, the compressor drive belt
tension should be checked at least
once a month.
To check the drive belt tension, press
down on the belt halfway between the
engine crankshaft and compressor
pulleys. Pressing with your finger, you
should not be able to deflect this belt
anymore than 8.0 mm. If you have the
instruments to check it with a force of
98N (22 lb.), the deflection should be
approx. 8.0 mm (0.315 in.). If the belt is
too loose, have it adjusted by your
Hyundai dealer.
DO-IT-YOURSELF MAINTENANCE
CHECKING THE CLIMATE
CONTROL AIR FILTER
B145A03HR-GAT
(For Evaporator and Blower
Unit) (If Installed)
The climate control air filter is located in
the hood.
It helps to decrease the amount of
pollutants entering the car.
B145A01HR
1. Open the hood.
2. Remove the filter by pressing the
upper end of the filter.
3. Clean the filter with compressed air
or water.
4. Reassemble in the reverse order of
disassembly after the filter is com-
pletely dried.
6
19