Hyundai 2003 Accent Owner's Manual page 158

6- 22
DO-IT-YOURSELF MAINTENANCE
G290B02A-AAT
Adjustment After Headlight Assembly
Replacement
0.8 in. (21mm)
Horizontal line
0.55 in. (14mm)
Cut-off line
H
If the vehicle has had front body repair and the
headlight assembly has been replaced, the head-
light aiming should be checked using an aiming
screen as shown in the illustration. Turn on the
headlight switch. (Low Beam Position)
1. Adjust headlights so that main axis of light is
parallel to center line of the body and is
aligned with point "P" shown in the illustra-
tion.
2. Dotted lines in the illustration show the cen-
ter of headlights.
SPECIFICATIONS:
"H";
Horizontal center line of headlights from
Vertical line
ground : 25.8 in. (656 mm)
W
"W";
Distance between each headlight center :
"P"
42.4 in. (1,078 mm)
H "L";
Distance between the headlights and the
wall that the lights are tested against:s 118
in. (3,000 mm).
Ground
line
L
G290B01A-1
G260A02A-AAT
REPLACEMENT OF LIGHT BULBS
Before attempting to replace a light bulb, be sure
the switch is turned to the "OFF" position.
The next paragraph shows how to reach the
light bulbs so they may be changed. Be sure to
replace the burned-out bulb with one of the
same number and wattage rating.
See page 6-27 for the wattage descriptions
!
CAUTION:
Keep the lamps out of contact with petro-
leum products, such as oil, gasoline, etc.