Setting Up The Machine; Electrical Connection; Foot Controller - Singer SE300 Instruction Manual

ELECTRICAL CONNECTION

DANGER
To reduce the risk of electric shock:
Never leave unattended when plugged in. Always
unplug this machine from the electric outlet
immediately after using and before maintenance.
WARNING
To reduce the risk of burns, fire, electric shock, or
injury to persons:
Do not unplug by pulling on cord. To unplug, grasp
the plug, not the cord.
1. Place machine on stable surface.
2. Connect the power line cord to the machine by inserting
the 2-hole plug into the power cord connector.
3. Connect the power line plug to the electric outlet.
4. Turn on the power switch.
5. The lamps will light up when switch is turned on (symbol I).
6. To disconnect, turn the power switch to the off position (symbol
O), then remove plug from outlet.
FOR UNITED STATES AND CANADA USERS:
POLARIZED PLUG INFORMATION
This appliance has a polarized plug (one blade wider than the
other). To reduce the risk of electric shock, this plug is intended
to fit in a polarized outlet only one way. If the plug does not fit
fully in the outlet, reverse the plug. If it still does not fit, contact
a qualified electrician to install the proper outlet. Do not modify
the plug in any way.
S u
ettIng p the

FOOT CONTROLLER

Use of foot controller will permit control of start, stop and speed
with your foot.
When the foot controller is connected, Start/Stop button will be
deactivated. (Next page)
1. Turn off the power switch. (symbol O)
2. Push foot controller plug into the connector on machine.
3. Place foot controller at your feet.
4. Turn on the power switch.
5. A lamp will light up when switch is turned on.
6. The harder you press the foot controller, the faster the
machine will sew. The machine will stop when foot
controller is released.
WARNING
To reduce the risk of burns, fire, electric shock, or
injury to persons:
1. Turn off the power when connecting the foot controller
to the machine.
2. Handle the foot controller with care and avoid dropping
it on the floor. Be sure not to place anything on top of
it.
3. Use only foot controller provided with this machine. (type
C-9001 manufactured by CHIEN HUNG TAIWAN Ltd)
10
m
achIne