Table of Contents
Advertisement
t
c
(I)
hread
utter
Use this cutter if the Thread Cutter button is not used.
1. Raise the presser foot and bring fabric and threads
backward after sewing.
2. Hook the threads to the thread cutter from back to front.
3. Pull the thread tails to cut the threads.
p
r
(J)
reSSure
egulator
The correct presser foot pressure allows fabrics to feed
properly while sewing. The setting of the presser foot pressure
is determined mainly by the weight of the fabric being sewn.
For lightweight fabrics such as sheers, batiste, voile, etc, the
pressure is decreased. For heavyweight fabrics like denim or
canvas, the pressure in increased.
To increase the pressure, turn dial to 5.
To decrease the pressure, turn dial to 1.
For most fabrics, turn dial to N.
t
c
(k)
op
over
To open the top cover, lift up the front right side of the cover.
h
w
(l)
and
heel
By turning the hand wheel, the needle will raise or lower. You
should always turn hand wheel toward you.
S
u
ettIng
p the
d
f
l
(m)
rop
eed
ever
The feed dogs project up through the needle plate, directly
below the presser foot. Their function is to move the fabric
while it is being sewn. The Drop Feed Lever located on the
back of the free arm controls the feed dogs.
For ordinary sewing, move the lever to the right. This raises
feed dogs to their highest position. For most sewing, the lever
should be in this position.
For darning or free-motion embroidery, or whenever fabric is to
be moved by hand, move the lever to the left to lower the feed
dogs.
NOTE:
After sewing with the feed dogs lowered, push the Drop
Feed Lever back to the right to resume sewing with feed
dogs engaged. Push the lever to the right and then turn the
handwheel toward you one full revolution. This will re-engage
the feed dogs.
M
m
m
ountIng
achIne In
There are two holes on the underside of the machine designed
for mounting the machine into a sewing cabinet. Align the
holes (indicated in the picture) with the corresponding holes in
the cabinet base. Attach the machine with screws. (Screws not
included)
12
m
achIne
S
c
(n)
ewIng
abInet
N
Advertisement
Table of Contents
