Automatic Bar-Tack And Darning - Singer SE300 Instruction Manual

S
ewIng

AUTOMATIC BAR-TACK AND DARNING

You can sew automatic bar-tack and darning using the
Buttonhole Foot.
No. 16 Bar-tack, to reinforce areas that will be subject to strain,
such as pocket corners.
No.17 Darning, mending and other applications.
Buttonhole Foot
1. Adjust slide on base of Buttonhole Foot according to the
length of the bar-tack or darning to be sewn.
a= Length of bar-tack or darning
2. Pass upper thread through the hole of Buttonhole Foot and
bring upper thread to the left.
3. Position fabric under presser foot so that the starting point
is on the thick area.
Lower the foot.
b. When sewing the bar-tack on the edge of thick fabric, such
as a pocket, place a cardboard or fabric piece of the same
thickness beside the fabric to help keep the foot level as
you sew.
4. Lower the Buttonhole Lever completely.
NOTE:
Machine will not start to sew if Buttonhole Lever is not
lowered properly or buttonhole foot is not positioned
correctly.
5. Hold upper thread lightly and start the machine.
6. Machine will sew bar-tack or darning stitch, as shown.
Machine will stop automatically when the pattern is finished.
1
7. Press the Thread Cutter button and raise the presser foot
lifter to remove the fabric.
31
2 3 4
1 2