VTech IS8251 Quick Start Manual page 7

been corrected. Replacement
this telephone equipment can only
be made by the manufacturer or its
authorized agents. For replacement
procedures, follow the instructions
outlined under the "Limited warranty".
If this equipment is causing harm to
the telephone network, the telephone
service provider may temporarily
discontinue your telephone service.
The telephone service provider
is required to notify you before
interrupting service. If advance notice
is not practical, you will be notified as
soon as possible. You will be given the
opportunity to correct the problem
and the telephone service provider is
required to inform you of your right
to file a complaint with the FCC. Your
telephone service provider may make
changes in its facilities, equipment,
operation, or procedures that could
affect the proper functioning of
this product. The telephone service
provider is required to notify you if
such changes are planned.
If this product is equipped with a
corded or cordless handset, it is
hearing aid compatible. If this product
has memory dialing locations, you may
choose to store emergency telephone
numbers (e.g., police, fire, medical) in
these locations. If you do store or test
emergency numbers, please:
Remain on the line and briefly explain
the reason for the call before hanging
up.
Perform such activities in off-peak
hours, such as early morning or late
evening.
to Industry Canada
This device contains licence-exempt
transmitter(s)/receiver(s) that comply
with Innovation, Science and Economic
Development Canada's
exempt RSS(s).
Operation is subject to the following
two conditions:
(1) this device may
interference, and (2) this device must
accept any interference, including
interference that may cause undesired
operation. Privacy of communications
may not be ensured when using this
telephone.
The term ''IC:'' before the certification/
registration number only signifies
that the Industry Canada technical
specifications were met.
The Ringer Equivalence Number (REN)
for this terminal equipment is 1.0. The
REN is an indication of the maximum
number of devices allowed to be
connected to a telephone interface.
The termination on an interface may
consist of any combination of devices
subject only to the requirement that the
sum of the RENs of all the devices does
not exceed five.
This product meets the applicable
Innovation, Science and Economic
Development Canada
specifications.
California Energy Commission Battery
charging testing instructions
This telephone is set up to comply
with the energy-conserving standards
right out of the box. These instructions
are intended for California Energy
Commission (CEC) compliance testing
only. When the CEC battery charging
testing mode is activated, all telephone
functions, except battery charging, will
be disabled.
licence-
To activate the CEC battery charging
testing mode:
1. Unplug the telephone base power
not cause adapter from the power outlet.
Make sure all handsets are plugged
with charged batteries before
proceeding.
2. While you press and hold FIND HS,
plug the telephone base power
adapter back to the power outlet.
3. After about 20 seconds, when
the HOME light starts flashing,
release FIND HS and then press it
again within two seconds. You hear
a confirmation tone. The
light turns on and all handsets
display To register HS... see manual
alternately. Allow up to one minute
for the process to complete.
If the phone fails to enter this mode,
repeat all the steps mentioned above.
The telephone base will be powered
up as normal if you fail to press FIND
HS within two seconds in Step 3.
To deactivate the CEC battery charging
testing mode:
technical 1. Unplug the telephone base power
adapter from the power outlet,
and then plug it back in. Then the
telephone base is powered up as
normal.
2. Put the handsets on the telephone
base cradle to begin registration.
3. The handset shows Registering...
If the registration is successful, the
handset screen displays Registered
and beeps. The
registered with the telephone base.
HOME
handset is