Table of Contents
Advertisement
3.4.2
EXPLANATION SERVICE ACTIVITIES
General;
The service and maintenance schedules (refer to Section 3.4.3.1, Page 47 )
use the codes as explained in the table below;
Service activities
Legend for service and maintenance intervals
Item
1
2
3
4
5
Remarks
1.
The indicated activities to be performed as specified in other GEA Grasso
documentation: Parts List (PL), Product Information (PI), Installation and
Maintenance Manual (IMM), Service Instruction Manual (SIM)
2.
Unless otherwise stated: All checkpoints have to be visually assessed for
irregularities like leakages, fractures, overheating, discolourations, dents,
bursts, presence of sludge, debris and solid particles etc.
3.
If applicable, also the original manufacturer's documentation has to be
consulted. Particularly for the various detection and controlling devices i.e.
solenoid valves, level switches, sensors and pressure switches
3.4.3
Maintenance compressor V (HS, HP) Series
General remarks about check list;
1.
Check list for compressor only; all other components have to be maintained
according to their specific manuals (IMM and SIM).
2.
All items of the list below marked "check", have to be checked visually and
checked for proper working.
3.
Some components have to be measured.
For measuring details refer to SIM.
4.
Measuring means also that visual inspection is required.
0089288_imm_v_english_19
07.04.2021
Warning!
These operations cover routine maintenance and are meant as a guide
only. Lack of maintenance, frequency of stop/starting, extreme
operating conditions etc could lead to accelerated wear.
Code/
Description
Actions
Inspect
Visual Inspection (Replacement when out of specs or in bad condition)
Check
Check / Test (functional or electrical, Correct if necessary)
Replace
Replacement / Renewal (Prescribed)
Measure Measurement of relevant dimensions (Replace when out of specs)
Clean
Clean
MAINTENANCE
SERVICE MAINTENANCE SCHEDULE
45
Advertisement
Table of Contents
Troubleshooting
