Connecting The Terminal Block; Figure 2-9 Connecting The Terminal Block - Siemens SIMATIC TI505 User Manual
High speed counter encoder module
Hide thumbs
Also See for SIMATIC TI505:
- User manual (91 pages) ,
- Installation and operation manual (66 pages) ,
- User manual (94 pages)
Table of Contents
Advertisement
Connecting the
Terminal Block
High Speed Counter Encoder Module User Manual
To connect the terminal block to the module, follow these steps. (See
Figure 2-9.)
1.
Align the terminal block with the edge card connector on the bezel.
2.
Press firmly at both ends of the terminal block until it is seated.
3.
Tighten the screws at the top and bottom. Do not over-tighten.
Not Available in Electronic Format.
Refer to your hard copy.
Figure 2-9 Connecting the Terminal Block
Installing the Module
2-11
Advertisement
Table of Contents
