Warnings - Dometic Go Power GP-PWM-10-SQ User Manual

Disconnect all power sources
Battery and wiring safety
Observe correct polarity
Do not exceed the GP-PWM-
10-SQ Amp current and max
[page 6] | gpelectric.com
Wiring connections
Work safely
at all times
voltage ratings
Electricity can be very dangerous. Installation should be performed only
by a licensed electrician or qualified personnel.
Observe all safety precautions of the battery manufacturer when handling
or working around batteries. When charging, batteries produce hydrogen
gas, which is highly explosive.
Ensure all connections are tight and secure. Loose connections may generate
sparks and heat. Be sure to check connections one week after installation to
ensure they are still tight.
Wear protective eye wear and appropriate clothing during installation.
Use extreme caution when working with electricity and when handling
and working around batteries. Use properly insulated tools only.
Reverse polarity of the battery terminals will cause the controller to give
a warning tone. Reverse connection of the array will not cause an alarm
but the controller will not function. Failure to correct this fault could
damage the controller.
The current rating of the solar system is the sum of the Maximum Power
Current (Imp) of the solar PV strings in parallel. The resulting system Imp
current is not to exceed 10A. The voltage of the array is the rated open
circuit voltage (Voc) of the PV array and is not to exceed 28V. If your
solar system exceeds these ratings, contact your dealer for a suitable
controller alternative
.

2. WARNINGS