Filling Station Information - Ford F-150 2000 Introduction Manual

Filling station information

Item
Required fuel
Fuel tank capacity-4 x 4 Regular
cab with short wheelbase
Fuel tank capacity-4 x 2 Regular
cab, SuperCab and SuperCrew
with short wheelbase
Fuel tank capacity-All long
wheelbase
Engine oil
(includes filter change)
Tire size and pressure
Hood release
Coolant capacity
Power steering fluid capacity
Transmission fluid capacity
1
Use Ford Premium Engine Coolant (green in color). DO NOT USE Ford
Extended Life Engine Coolant (orange in color). Refer to Adding engine
coolant, in the Maintenance and Care chapter.
2
Ensure the correct automatic transmission fluid is used. Transmission fluid
requirements are indicated on the dipstick or on the dipstick handle. Check the
container to verify the fluid being added is of the correct type. Refer to your
scheduled maintenance guide to determine the correct service interval.
Some transmission fluids may be labeled as dual usage, such as MERCON and
MERCON V. These dual usage fluids are not to be used in an automatic
transmission that requires use of the MERCON type fluid. However, these dual
usage fluids may be used in transmissions that require the MERCON V type
fluid.
MERCON and MERCON V type fluids are not interchangeable. DO NOT
mix MERCON and MERCON V. Use of a transmission fluid that
indicates dual usage (MERCON and MERCON V) in an automatic
transmission application requiring MERCON may cause transmission
damage. Use of any fluid other than the recommended fluid may cause
transmission damage.
280
1
2
Information
Unleaded fuel only - 87 octane
92.7L (24.5 gallons)
94.6L (25.0 gallons)
113.6L (30.0 gallons)
5.7L (6.0 quarts). Use Motorcraft SAE
5W-20 Super Premium Motor Oil, Ford
specification WSS-M2C153-H.
Refer to the Certification Label inside
of drivers's door.
Pull handle under the left side of the
instrument panel.
Refer to Refill capacities in the
Capacities and specifications chapter.
Fill to line on reservoir. Use Motorcraft
MERCON ATF.
Refer to Refill capacities in the
Capacities and specifications chapter.