Terex Genie ZX-135/70 Service Manual page 173

September 2015
Sensor With key switch
the enter button and turn key switch
Calibration
to on position.
(software version
Release the enter button and press
4.01 and higher)
(plus)(enter)(enter)(plus).
Part No. 218700
, press and hold Set unit X-axis to gravity
OFF
Set unit Y-axis to gravity
Set platform level to gravity (YES/NO)
Platform level sensor millivolts/degree
Delete axles angle sensors
calibration? (YES/NO)
YES: Axle angle fully retracted
(YES/NO)
YES: Axle angle fully extended
(YES/NO)
Delete all steer sensors calibrations?
(YES/NO)
Delete blue end blue side steer sensor
(FL) calibration? (YES/NO)
Delete yellow end blue side steer
sensor (RL) calibration? (YES/NO)
Delete blue end yellow side steer
sensor (FR) calibration? (YES/NO)
Delete yellow end yellow side steer
sensor (RR) calibration? (YES/NO)
Delete secondary boom angle sensor
calibration? (YES/NO)
Secondary boom fully lowered?
(YES/NO)
Secondary boom fully raised?
(YES/NO)
Delete primary boom angle sensor
calibration? (YES/NO)
Primary boom fully lowered?
(YES/NO)°
Primary boom fully raised? (YES/NO)°
Delete jib level angle sensor
calibration? (YES/NO)
Jib level cylinder fully extended?
(YES/NO)
Jib level cylinder fully retracted?
(YES/NO)
ZX-135/70
Service Manual
Display Module
Use +/- buttons to adjust
157