Fujitsu ASU30RLE Service Instruction page 95

3-1-2 PROCEDURES TO CHANGE THE FUNCTION SETTING FOR WIRELESS RC
This procedure changes to the function settings used to control the indoor unit
according to the installation conditions.
Incorrect settings can cause the indoor unit malfunction.
After perform the "FUNCTION SETTING" according to
the installation conditions using the remote controller.
Settings will not be changed if invalid numbers or setting values are selected.
Entering the Function Setting Mode
While pressing the POWERFUL button and SET TEMP.( ) button simultaneously,
press the RESET button to enter the function setting mode.
Selecting the Function Number and Setting Value
(1) Press the SET TEMP.( ) ( ) buttons to select the function number.
(Press the MIN. HEAT button to switch between the left and right digits.)
(2) Press the POWERFUL button to proceed to setting the value.
(Press the POWERFUL button again to return to the function number
selection.)
(3) Press the SET TEMP.( ) ( ) buttons to select the setting value.
(Press the MIN. HEAT
(4) Press the MODE button, in the order listed to confirm the setting.
Please confirm that the beep sounds.
(5) Next, please press the START/STOP(
Please confirm that the beep sounds.
(6) Press the RESET button to cancel the function setting mode.
(7) After completing the FUNCTION SETTING, be sure to disconnect
the power and connect it again.
After disconnect the power, wait 10 seconds or more
before connect it again.
The FUNCTION SETTING doesn't become active unless
the power is disconnect the reconnected again.
button to switch between the left and right digits.)
) button.
CAUTION
03-06
MIN.
MIN.
Function
Number
Setting Value
MIN.