Setting Up Your Scanner - Raven Original 2nd Generation User Manual

Setting Up Your Scanner

Install the Scanner
1.1 Hold the ADF Paper Tray and insert
two pins to the holes on the top of the scanner
.
as shown
Connect to Power
11
1.2 Fold down the output tray. Pull the Output
Tray and raise the paper stopper to prevent
paper from falling.
2.1 Connect one end of the power cable to the power
receptacle of the scanner.
Connect the other end to an appropriate power outlet.
ATTENTION: Please make sure the scanner is
turned OFF before you plug or unplug the scanner
power adapter.
2.2 (Optional) To use a wired internet connection, connect
one end of your Ethernet LAN cable to an available port of
your Ethernet Hub (router/modem). Connect the other end
to the port marked at the back of the product.
support@raven.com | 1-800-713-9009 | raven.com/support