Federal Communications Commission (Fcc) Compliance Information Statement - Raven Original 2nd Generation User Manual

Federal Communications Commission (FCC) compliance information
statement
Part 15
This hardware has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
hardware generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this hardware does cause harmful interference to radio or
television reception, which can be determined by turning the hardware off and on. The
user is encouraged to try to correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the hardware and receiver.
● Connect the hardware into an outlet on a circuit different from that to which the
receiver is connected.
● Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
FCC Caution:
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this hardware.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the
antenna and users.
2) The transmitter module may not be co-located with any other transmitter or
antenna.
FCC Radiation Exposure Statement:
This hardware complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This hardware should be installed and operated with minimum distance
20cm between the radiator & your body. To maintain compliance with FCC RF exposure
compliance requirements, please avoid direct contact to the transmitting antenna
during
transmitting.
5
support@raven.com | 1-800-713-9009 | raven.com/support