Table of Contents
Advertisement
Jumper
Description
JBT1
Clear CMOS
JPB1
BMC Enable
JPG1
VGA Enable
JPL1
GLAN1/GLAN2 Enable (X10DRG-H)
10_GLAN1/10G_LAN2 Enable (X10DRG-HT)
JPME2
Manufacture (ME) Mode Select
JWD1
Watch-Dog Timer Enable
Connectors
Battery (BT1)
COM1
FAN 1/2/3/4, FAN
A/B/C/D/E/F/G/H
JF1
JL1
JPC1
JPCIE1_1
JPCIE1_3
JPW1
JPW2
JPW3/JPW4/JPW5/
JPW6/JPW7
JSPK1
JSTBY1
JTPM1
LAN1/LAN2
(IPMI)_LAN
(I-)SATA 0-5
(S)-SATA0-3
T-SGPIO1/2/3
(CPU1) SLOT1/3
(CPU2) SLOT2/4
(CPU2) SLOT5
Chapter 5: Advanced Serverboard Setup
X10DRG-H(T) Jumpers
X10DRG-H(T) Connectors
Description
Onboard CMOS Battery (See Chpt. 3 for used battery
disposal)
Backplane COM port
CPU/System fan headers (Fan 1-4, Fan A-H)
Front_Panel_Control header
Chassis intrusion
3-pin header
Proprietary SPEC Slot 1 (See Note 1 on Page 1-6.)
Proprietary SPEC Slot 1 (See Note 1 on Page 1-6.)
Proprietary main power connector
8-pin power connector
12V 8-Pin power connectors used for HDD backplane or
GPUs
Internal buzzer/speaker
Standby power connector
TPM (Trusted Platform Module)/Port 80 header
G-bit Ethernet (GLAN) ports 1/2 (for X10DRG-H)
10 G-bit Ethernet (GLAN) ports 1/2 (for X10DRG-HT)
IPMI_Dedicated LAN support by the Aspeed controller
Intel SATA 3.0 connectors (0-5) from Intel PCH
SATA connectors (0-3) from Intel SCU
Serial_Link General-Purpose I/O (SGPIO) headers for
I-SATA connections (I-SGPIO1 for I-SATA0-3, I-SGPIO2
for I-SATA4/5, I-SGPIO3 for S-SATA0-3)
PCI-Exp. 3.0 x16 Slot1/Slot3 supported by CPU1
PCI-Exp. 3.0 x16 Slot2/Slot4 supported by CPU2
PCI-Exp. 3.0 x8 in x16 slot supported by CPU2
5-11
Default Setting
See Chapter 2
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Enabled)
Pins 1-2 (Normal)
Pins 1-2 (Reset)
Advertisement
Table of Contents
