System Settings - T+A MP 200 User Manual

System settings

Source
configuration
j
Display brightness
Display mode
28
At this menu item you can activate and disable not used sources, and assign a plain text
name to each source; this name then appears in the screen displays.
You can also assign a plain text name for the display to the external sources (digital in-
puts and Bluetooth).
When this menu item is called up with the
appears.
Each source is followed by the displayed plain text name or the note Enabled for an
active source or Disabled if the source is deactivated.
Deactivate not required sources
A long press on the
To activate a source, press the
Change the source name
To change the plain text name, first select the corresponding source and press the
button.
Delete the previous name by repeatedly pressing the
Enter the new name using the cursor keys.
Apply entry
Delete previous
digit
To switch between numeric and alphanumeric input as well as upper/lower case, press
the button.
If you should wish to restore the factory default source name, erase the whole name
before saving the empty field with the
standard source names.
These settings can only be changed by using the remote control.
At this point you can adjust the brightness of the integral screen to suit your personal
preference for normal use.
Here you can set whether the display will be switched on permanently or only tempora-
rily, when the device is being operated.
If the setting temporary is selected, the display is switched on during operation of the
MP 200 only and then automatically switched off again after a short delay.
If the Always ON setting is selected, the display remains permanently on.
button, a list of all sources of the MP 200
button deactivates the selected source.
button briefly.
Select letter / number / symbol
Next digit
Select letter / number / symbol
button: this action resets the display to the
button.