T+A MP 200 User Manual page 50

Transmission interruptions occur when listening to internet radio stations.
Cause:
The capacity of the internet radio station's server is at its limit.
Remedy:
Choose a different station.
The streaming client cannot connect to a network.
Cause 1 (cable LAN):
Network cable not properly connected
Remedy:
Connect network cable, check connection to router
Cause 2 (wireless LAN):
WLAN antenna not connected or placed in a location with bad reception quality
Remedy:
Connect WLAN antenna properly and find a location with good reception quality.
Set the transmission power output of your WLAN router to maximum.
Try to establish a network connection first in a location close to the WLAN router. If this succeeded try
to connect to WLAN from a more remote location. Experiment with antenna position and try to find a
location with better reception quality.
Cause 3 (wireless LAN):
WLAN reception quality bad (low field strength). Possibly too much attenuated by walls/ceilings on the
transmission path.
Remedy:
Optimize location of receiver and transmitter antennas.
Alternative:
If transmission problems persist a so called ‚Power Line' network might be good alternative to establish
a good and stable network connection.
The best, safest and most secure network however will always be a cable LAN network.
Cause 4:
Network parameters not properly configured.
Remedy:
Configure the network parameters correctly (see chapter ‚Network configuration').
Cause 5 (operation without network connection):
For proper operation the MP 200 needs at least one properly connected network device. This can be a
LAN or WLAN network or a USB storage device.
Remedy:
If the MP 200 shall be operated without network (LAN / WLAN) please connect at least a USB stick.
USB Storage device is not recognised
Cause 1:
The storage device (especially USB hard discs without separate power supply) draws more electrical cur-
rent from the USB interface than is permitted by the USB standard.
Remedy:
Only use USB storage devices that conform to the USB standard or use storage devices with own power
supplies.
Cause 2:
The storage device is not formatted with an appropriate file system.
Remedy:
The MP 200 accepts storage devices with FAT16 or FAT32, NTFS, Ext2, Ext3, Ext4 file systems.
50