Bluetooth Antenna; Connection Of Digital Source Devices; Connected To A Dac 200 Or Ha 200; Operation With Other Devices - T+A MP 200 User Manual

BLUETOOTH antenna

For audio streaming via Bluetooth, e.g. from a smartphone to the MP 200 , one of the two antennas must
be connected to the BT socket.

Connection of digital source devices

At the digital inputs of the MP 200 (Digital IN) you can connect devices with electrical coax or optical fiber
output.
The MP 200 accepts at all inputs digital stereo signals according to the S/P-DIF standard with sampling rates
j
from 32 kHz to 192 kHz.

Connected to a DAC 200 or HA 200

The MP 200 is designed for operation in conjunction with the DAC 200 or HA 200. For this purpose, the MP
200 is equipped with the system interfaces USB SYS and SYS IN/OUT.
If the MP 200 will be operated in conjunction with a DAC 200 or HA 200, these two interfaces must be con-
nected. See also the wiring diagrams in the chapter Connection and cabling.

Operation with other devices

For operation with other DACs or amplifiers, connect the DIG OUT digital output to the corresponding digi-
tal input of the device you are using.

Connecting the power cord

Connect the mains cable to the mains socket of the MP 200 and then connect the device to the wall outlet.
To achieve the maximum signal-to-noise ratio, the mains plug should be plugged into the wall outlet in
such a way that the phase is connected to the contact of the mains input socket which is marked with a
dot. The phase of the mains socket can be determined with a measuring device suitable for this purpose.
Please contact your specialist dealer.
21