T+A MP 200 User Manual page 33

Configuration using the WPS function
• First activate the WPS-function of the Router or Repeater to which you wish the MP 200 to be connec-
ted. For details please refer the manual of the device in question.
• Start the WPS-Autoconnect function of the MP 200 within 2 minutes.
• Use the buttons to select the menu point "WPS-Autoconnect", then confirm your choice
with the button.
• After the connection is established, the line Status shows the connected WLAN network.
• Finally select the "Store and exit?" menu point and press the
Manual setup of the WLAN connection
• First select the Scan for WLAN menu item and confirm it with the button.
• A list of the WLANs found appears.
• Use the buttons to select the WLAN to which you wish the MP 200 to be connected, and confirm
your choice with the
• Enter the network password (passphrase) and confirm your entry with .
• Confirm and store the settings by selecting the item Store and exit? and pressing
• Finally, select the menu item Store and exit? again and confirm the settings with the
Setting up the WLAN connection via the T+A app
The MP 200 supports setting up the WLAN connection via an access point. This means that the MP 200
provides its own WLAN for the duration of the configuration of the WLAN settings. As soon as the configu-
ration is complete, this WLAN is deactivated again. The MP 200 restarts and connects to the WLAN confi-
gured via the app.
• Turn on the MP 200 and open the system configuration menu by pressing the
control or the SYS button on the front of the MP 200.
• Use the buttons to select the menu point Network, then confirm your choice with the
• Use the buttons to select the menu point Access Point, then confirm your choice with the
ton.
• The MP 200 activates the WLAN access point.
• The following steps must be performed within approximately 5 minutes. After this time, the MP 200 will
exit access point mode automatically.
• Connect the smartphone or Tablet PC on which the T+A-app is installed to the WLAN access point. The
network name (SSID) is „T+A AP MP 200" and the passphrase is "01234567".
• Start the T+A-app for operation.
• The app recognizes the access point and starts automatically with the setup wizard.
• To set up the WLAN, go through the individual steps of the app's setup wizard.
• Quit the app, then connect your phone or tablet to your previously set up wireless LAN.
• After restarting the app the MP 200 will be detected automatically.
• Once the MP 200 is detected, it can be selected for playback.
button.
button to accept the settings.
(TA Music Navigator)
.
button again.
button on the remote
button.
but-
33