Switching On And Off; Connecting To Network - T+A MP 200 User Manual

Switching on and off

• In stand-alone operation and in conjunction with a DAC 200 or HA 200, the MP 200 can be switched on
and off by briefly tapping the
• When operating in conjunction with a DAC 200 or HA 200, the devices can be switched off together using
the button on the DAC or HA.
• To switch on, either tap the
• It is also possible to switch on the MP 200 directly with a source selection button on the device or the
source selection rocker on the remote control.
Example:
If you tap the source selection button DISC on the MP 200, it switches on with the source Disc. A possibly
connected DAC 200 or HA 200 is automatically switched on and set to the system input SYS IN for play-
back.

Connecting to network

Wired network connection
If the MP 200 will be operated via a LAN connection and not via WLAN, connect the LAN port to an opera-
tional network (router) with Internet access as shown in Fig. 1.
After switching on and booting the streaming module, the device will automatically connect to your net-
work.
We recommend a wired network connection via LAN cable for streaming high-resolution music material.
j
Depending on the reception quality and the traffic load from other users, a WLAN connection can reach its ca-
pacity limit more quickly, which may lead to playback dropouts.
Set up a WLAN connection automatically via WPS
• Make sure that the WLAN antenna is connected correctly. (Fig. 1)
• Start the WPS function of your router / access point (refer to the router's manual for information).
• Now open the system settings by a brieg press on the SYS button on the front panel of the MP 200.
• Select the Network menu item by turning the SELECT knob and confirm by pressing the SELECT knob.
• Then select the WPS Autoconnect menu item by turning the SELECT knob.
• Start the WPS function of the MP 200 by pressing the SELECT knob.
• Wait until the device has automatically connected to the WLAN and the name of the network has been
adopted in to the field Status.
• Exit the menu by a briefly pressing the SYS button again.
If you prefer manual setup or setup via access point and our T+A Music Navigator App, you will find more infor-
j
mation regarding WLAN setup in the chapter Network configuration starting on page 31.
14
button on the MP 200.
button on the device or the
Source selection rocker
Source selection buttons
button on the remote control.