Notes On Energy Saving; General Information; Automatic Power Down Function; Legal Information - T+A MP 200 User Manual

Table of Contents

Notes on energy saving

The MP 200 satisfies the requirements of the latest directives concerning energy-saving measures (EuP

directive). The modern design of the mains power supply makes an important contribution to this.

The internal micro-processor constantly ensures that sub-assemblies which are not currently required

are automatically switched off. The micro-processor itself operates in stand-by mode at a relatively low

clock speed, and only responds to the remote control receiver.

In stand-by mode the current drain of the MP 200 is less than 0.5 Watt.

If you intend not to use the device for a long period, it should be disconnected from the mains socket, i.e.

the mains plug should be withdrawn from the wall socket.

The device features an automatic power-down function. If the MP 200 detects no operation or no music

signal for a period longer than 90 minutes, it automatically switches to stand-by mode

In countries outside the EU, in which the EuP directive has no validity, the automatic power-down feature can

be disabled if necessary. See chapter „System settings".

This product contains software in form of object code that is partially based on free software under diffe-

rent licenses. Details of the licenses used can be viewed on the device website using an Internet browser.

To access the devices web page, enter the IP address of the device and „/licensens/" in the address bar of

the browser you are using.

For example http://192.168.178.100/licenses/

You can view the exact address as follows:

• Call up the system configuration menu by pressing the SYS button on the MP 200.

• Then navigate to the Device Info menu item.

• Open it by pressing the SELECT knob and then navigate to the Legal Information menu item and open it

by pressing the SELECT knob again.

• The address of your device is displayed in the pop-up window that now opens.

The address is only displayed in the pop-up window if the device has a correctly configured network connec-

tion. For details on network configuration, see the „Network Configuration" section.

To view the devices website, the device on which the internet browser is launched must be connected to the

same network as the device.

Table of Contents