Table of Contents
Advertisement
Page
| 21
Autopilot LED indicator
To verify the signal is being received by the Jupiter Autopilot there are LED indicators
located on the Autopilot case, the LED in relation to the landing sensors are number one
and two. If the landing laser detects less than 50mm (Yellow and Green LED simultaneous)
will NOT be
illuminated. If the landing sensor detects over
the Green LED on the autopilot
50mm (Green LED only) then the Autopilot LED
WILL be
illuminated. To check the distance
is working correctly, lift the Galaxy over 50mm (2") by rotating the nose forward to raise the
rear landing gear and landing sensors.
Below is an image of the autopilot LED, both LED 1 & 2 are illuminated indicating that the
landing sensor detects above 50mm or that sensor is not connected to the autopilot.
Interface control
The Landing sensors can be disabled to troubleshoot, you should never operate the Galaxy
without the landing sensors enabled. If the Galaxy was to be flown with the landing sensors
disabled, then upon landing the user
MUST
hold the altitude control down firmly and press
the start/stop button of the GCS to manually disarm the Galaxy instantaneously. Please
consult your distributor before attempting to fly without the landing sensors enabled.
| Version 1.5
INNOFLIGHT INTERNATIONAL GALAXY 950 / GALAXY 1080HL MANUAL
Advertisement
Table of Contents
