Table of Contents
Advertisement
Assembly
The Galaxy 950 comes prebuilt and fully tested, the system is then stored in the Galaxy 950
travel case. There are 6 main components to the Galaxy 950 assembly.
-
Main Body
-
Boom
-
DRS-10 Parachute
-
Landing leg (left)
-
Landing leg (right)
-
Ground Control Station
Landing Gear
The landing gear is preassembled in two halves (left & right), they are attached to the leg
clamp mounts already attached to the main body. Once the square carbon legs have been
installed, they are held in place by tightening the 4 M3 bolts on each leg clamp. When
tightening the bolts take care not to over tighten them. Apply a small amount of 243 Loctite
to each bolt to lock in place. Each landing leg has a sonar sensor that is connected to the
Galaxy body via an MPX connector. These sensors are used by the autopilot to detect the
landing protocol. These must both be connected for the autopilot to allow take off.
INNOFLIGHT INTERNATIONAL GALAXY 950 / GALAXY 1080HL MANUAL
Page
| 14
| Version 1.5
Advertisement
Table of Contents
