Table of Contents
Advertisement
Page
| 15
Boom Assembly
The boom is secured to the main body by inserting and clamping two M3 boom clamp bolts
to tighten around the tube. When inserting the boom, make sure that the rear vertical fin is
parallel to the main rotor shaft and the GPS plate is level. Once the boom is locked in place
connect the three connection plugs for the GPS, DRS-10 and tail motor.
DRS-10 Parachute installation
Refer to Page | 27 of this manual for DRS-10 information and installation.
Boom Removal
The boom can be easily removed for transport by loosening the bolts and disconnecting the
plugs, once disconnected the boom is able to slide back out of the main body.
| Version 1.5
INNOFLIGHT INTERNATIONAL GALAXY 950 / GALAXY 1080HL MANUAL
Advertisement
Table of Contents
