Evinrude 30 HORSEPOWER MFE Operator's Manual page 30

Using The Evinrude MFE Outboard
Running Mode
If any LED is ON while the outboard is run-
ning, it may indicate a system problem. Refer
to EMM Diagnostics Label.
LED 1, 2, or 3 ON, return to port as soon as
practical to avoid operational difficulties. Ser-
vice the engine as soon as possible.
LED 4 ON indicates:
• Engine temp. ABOVE range, refer to En-
gine Overheating on page 26.
• Low / No Oil condition. Refer to Filling the
Oil Tank and Priming the Oil System on
page 16.
- CHARGING
OK
- CRANK POSITION
OK
- SENSORS
OK
- LANYARD / STOP
OK
EMM DIAGNOSTICS
EMM Diagnostics Label
28
- CHARGING
FAULT
- INJECTOR / IGNITION
FAULT
- SENSOR
FAULT
- NO OIL / OVERHEAT
3011761
008539
Start Mode
If any of the LEDs does NOT light during start-
ing, it may indicate an engine problem. Refer
to EMM Diagnostics Label.
LED 1, 2, or 3 OFF, seek assistance to return
to port. See your Dealer.
LED 4 OFF indicates the stop circuit is activat-
ed, make sure the engine cut–off switch teth-
er cord is attached.