Evinrude 30 HORSEPOWER MFE Operator's Manual page 22

Using The Evinrude MFE Outboard
engine. Refer to Engine Overheating on
page 26.
1. Water pump indicator
Engine Stopping
Twist the throttle grip to SLOWEST speed po-
sition.
Move shift lever to NEUTRAL.
Press the engine cut–off switch until the out-
board stops running. If equipped, close the
vent screw on the fuel tank's filler cap.
1. STOP button
20
1
007011M
1
002413
Disconnecting the Fuel Hose
A WARNING
A small amount of fuel may be released
when the fuel connector is discon-
nected.
Always wipe off any fuel spillage.
Disconnect the fuel hose from the fuel con-
nector.
1. Fuel connector
If equipped, close vent screw on fuel tank cap.
1
007004