Pre-Ride Inspection - Evinrude E-TEC G2 Operator's Manual

Always perform a pre-ride inspection before operating the boat. Check the proper
operation of critical controls, safety features and mechanical components. Correct
any problems BEFORE leaving the dock. Make sure all safety equipment required by
local law is onboard.
The engine(s) should be OFF and the tether cord must always be removed from the
engine cut-off switch before verifying any of the following. Only start the engine(s)
after all items have been checked and operate properly.
ITEM
Hull
Propeller
Cooling system
Safety equipment
Oil level
Bilge
Battery
Fuel level
Navigation lights
Steering system
Boat systems (horn, pumps, radio)
Engine cut–off switch/ tether cord
Operator's Guide
Key / Engine Start switches
Displays & Gauges
Shift and Throttle
Trim System
Cooling system

Pre-Ride Inspection

WARNING
WARNING
Inspect.
Inspect condition of propeller. Repair or replace
damaged propeller.
Inspect water intake screens.
Ensure safety equipment is onboard.
Check. Refill as needed.
Drain. Ensure drain plug(s) are securely installed.
Check battery connections are clean, tight, and
insulated. Ensure battery/battery box are secure.
Check. Refill as needed.
Check operation.
Check operation.
Check operation.
Inspect condition of tether cord. Attach to key
switch or engine cut–off switch (depending on
application). Test operation. Reattach tether cord
to switch.
Confirm this Operator's Guide is onboard and
readily accessible.
Test operation.
Self-test and warning horn, check operation
Check operation.
Check operation.
Confirm operation (water pump indicator).
OPERATION

35