Weighing Units Selection - Detecto MedVue MV1 Owner's Manual

WEIGHING UNITS SELECTION

When the MedVue is turned on for the first time, it will display a prompt to select the weighing
units to use for your operation, lb (pounds) or kg (kilograms). The weighing units selection can
ONLY be made at this time and cannot be changed afterward. Make sure you select the
correct weighing units before proceeding.
IMPORTANT! Make sure you select the
correct weighing units. Once the weighing
units has been set, it cannot be changed.
Key Legend
ON/OFF Key
1. Press the ON/OFF key to turn the MedVue on.
2. The display will show the software version for a few seconds, and then change to show
UNITS
(in small letters at the bottom left), and a large
(pounds) annunciator flashing next to it.
3. If weighing in lb (pounds) is required for your operation, press the ENTER key to save it,
and then proceed to step 7.
4. Otherwise, if your operation requires weighing in kg (kilograms), press the 3 key.
5. The display will change to show a large
(kilograms) annunciator next to the large
UNITS
Note that will still be showing in smaller letters at the bottom left of the display.
6. Press the ENTER key to save the kg (kilograms) weighing units setting.
7. The scale is now ready for operation.
ENTER Key
3
at the top right of the display, and will flash the kg
3
.
8555-M512-O1 Rev E MedVue MV1 Owner's
1
at the top right, with the lb
9