Delivery; Storage; Pump Returning Back To The Supplier; Intended Use - Wilo -SCP Installation And Operating Instructions Manual

When lifting the pump in combination with the base plate, the
lifting tackle should be attached to the lifting lugs provided
on the base plate side member. The angle of the lifting ropes
should not exceed 8° if shackles are used and 24° if hooks are
used. To lift the pump the lifting slings should pass beneath
the pump body at suction and delivery flanges (see lifting
diagrams - see also general safety Information, chapter 2).
These must have sufficient load bearing capacity to ensure
that the product can be transported safely. (Refer figure 1 & 2
Pg.1)

3.2 Delivery

On arrival, the delivered items must be inspected for damage
and a check made that all parts are present. If any parts are
damaged or missing, the transport company or the
manufacturer must be informed on the day of delivery. Any
claim made at a later date will be deemed invalid. Damage to
parts must be noted on the delivery or freight documentation.

3.3 Storage

3.3.1 Short-term storage (less than 3 month)
The equipment as shipped have adequate protection for short
term storage in a covered, dry and ventilated location at the
job site prior to installation.
If the pump is not installed immediately after deli- very, it
must be stored in a dry and clean place with sufficient
ventilation, no vibration, no freezing and the temperature
variations must be smooth. Bearings and couplings must be
protected against sand, dust and foreign bodies. To avoid
corrosion and jamming, please lubricate the pump and make
turn the rotating elements for several turns at least once a
week. Prepacked desiccants may be used to absorb moisture
& keep the pump dry. It must be removed before putting the
pump on operation.
Installation and operating instructions WILO-Split Case Pumps
3.3.2 L o n g -term storage (more than 3 month)
If the equipment will be subject to extended storage
condition prior to installation, then the manufacturer must
be informed about storage duration, so that special
protection can be recommended.
• Place the SCP pumps horizontally on firm foundation and
secure it against falling.
• The pump set must be protected from direct sun light, heat,
dust, and frost.
• The rotors or propellers must be turned at regular intervals.
This prevents the bearing from locking and the film of
lubricant on the mechanical shaft seal is renewed.
• For mechanical seal, we recommend: relative air humidity
below 65%, temperature between 15°C and 25°C. Direct
exposure of the mechanical seal to heat (sun, heating) as well
as to ozone, present or produced by ultraviolet light (halogen
or fluorescent lamps), must be avoided because of the risk of
embrittlement of elastomeric materials.

3.4 Pump returning back to the supplier

Products, which are delivered back to the plant, must be
clean and correctly packaged. In this context, clean means
that impurities have been removed and decontaminated if it
has been used with materials, which are hazardous to health.
The packaging must protect the product against damage.
CAUTION! Guarantee not applicable!
Products, which are not suitably packaged for delivery
back, are no longer covered by guarantee!

4 Intended use

The pump supplied is intended for specific fluid. Refer pump
data sheet and order confirmation. For any change in
pumped fluid refer WILO beforehand. Horizontal split Case
pumps are used in water supply, water circulating systems,
injection water, spray pond, air-conditioning, water
treatment, sprinkler & drip irrigation, firefighting, juices etc.
If the operating conditions are different of the specifications
given in the order, (i.e. type of liquid, temperature or duty
point), the end user must ask a written agreement to WILO
on the new operating conditions before starting the pump.
10