Suitability For Use - Omron G3RV-SL700-A Series Manual

Mounting
<SSR Mounting Pitch (Panel Mounting)>
60mm min.
SSR
Vertical
direction
30mm min.
80mm min.
<Relations between SSR and duct (Depth of duct)>
Duct Depth Counter measure(1)
The recommended width is
1/2 as large as the depth of
Duct or air flow
SSR or less
obstruction
The depth
of SSR
Vertical
direction
SSR
Duct or air flow obstruction Duct or air flow
obstruction
Do not surrounded the SSR Use a short duct in
with the duct in the depth the depth direction.
direction, or otherwise the
heat radiation of the S5R
will be adversely affected.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS.
To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527.
Cat. No. J180-E1-02
14
Solid State Relays
Duct
Counter measure(2)
Duct or air flow
obstruction
Duct or air flow
obstruction
Air flow
Metal
base
SSR
Duct or air flow obstruction
If the height of the ducts
can not be lowered, place
the SSR or a metal base so
that they are not
surrounded by the ducts.
In the interest of product improvement, specifications are subject to change without notice.
G3RV
Authorised Distributors:-
Intech Systems Chennai Pvt. Ltd
S-2, Thiru. Vi. Ka. Industrial Estate, Guindy, Chennai-600 032
Ph: 4353 8888 Mob: 99 4353 8888 (Board Line) Fax: 044 4353 7888
E-mail: info@intechchennai.com Website: www.intechchennai.com
<Ventilation Outside the Control Panel>
SSR
Air inlet
If the air inlet or outlet has a filter, clean the filter regularly to
prevent it from clogging and ensuring efficient flow of air.
Do no locate any objects around the air inlet or air outlet, otherwise
the objects may obstruct the proper ventilation of the control panel.
A heat exchanger, if used, should be located in front of the G2RVs
to ensure the efficiency of the heat exchanger.
Please monitor the ambient temperature of the G3RV's. The rated
load current is measured at 25°C ambient temperature.
A G3RV uses semiconductor in the output element.
This causes the temperature inside the control panel to increase
due to heating resulting from the passage of electrical current
through the load. To the restrict heating, attach a fan to the
ventilation outlet or air inlet of the control panel to ventilate the
panel. This will reduce the ambient temperature of the G3RVs and
thus increase reliability.
(Generally, each 10°C reduction in temperature will double the
expected life.)
EMI
• This is a class A product. In residential areas it may cause radio
interference, in which case the user may be required to take
adequate measures to reduce interference.

Suitability for Use

OMRON shall not be responsible for conformity with any standards,
codes, or regulations that apply to the combination of the products in
the customer's application or use of the product.
Take all necessary steps to determine the suitability of the product
for the systems, machines, and equipment with which it will be used.
Know and observe all prohibitions of use applicable to this product.
NEVER USE THE PRODUCTS FOR AN APPLICATION INVOLVING SERIOUS
RISK TO LIFE OR PROPERTY WITHOUT ENSURING THAT THE SYSTEM AS A
WHOLE HAS BEEN DESIGNED TO ADDRESS THE RISKS, AND THAT THE
OMRON PRODUCT IS PROPERLY RATED AND INSTALLED FOR THE INTENDED
USE WITHIN THE OVERALL EQUIPMENT OR SYSTEM.
SSR
See also Product catalog for Warranty and Limitation of Liability.
Be aware of air flow
Duct
Ventilation
outlet
SSR
SSR