Attach Handlebars - Pacific Zuma Assembly And Maintenance Manual

Zuma Assembly and Maintenance Guide

13. Attach Handlebars

A. Slide a Handlebar in place on the Press Arm.
Handlebars curve inward; choose the correct
Handlebar.
B. Attach the Handlebar using
one ½-inch large washer
one ½-inch thin hat washer
one locknut
Place the thin hat washer so it cups upward.
Wrench tighten, still allowing movement.
C. Cover the end of the bolt with the black rubber cap.
Consider using the mallet to pound on the cap.
D. Repeat steps A through C for the other Handlebar.
E. Place a Row Handlebar on the Press Arm. Row
Handlebars curve to the right or the left from
the mounting plate; choose the correct Row
Handlebar.
F. Attach the Row Handlebar using
two 3-inch bolts
four washers
two locknuts
Insert one bolt from the back and one from the side.
Finger tighten both bolts, and then wrench tighten.
G. Repeat steps E and F for the other Row
Handlebar.
Step 13. Attach Handlebars
Press Arm
1 - ½" large washer
B
1 - ½" thin hat washer
1 - locknut
C
1 - black rubber cap
Row Handlebar
F
1 2
Handlebars
2 - 3" bolts
4 - washers
2 - locknuts
3 4 5
Press Arm
6
page 26